When the paint won’t behave.

The twenty-two problems painters ask about most, why they happen, and what to do instead.

My mixes keep turning muddy

Every medium

Mud usually means too many pigments (more than three), or warm and cool versions fighting each other. Cap each pile at two or three paints, mix with a clean knife, and choose pigments biased toward the target: a cool yellow and a cool blue for clean greens. Remember that “mud” in one context is a beautiful grey in another: it’s only wrong if it doesn’t fit.

My tints look chalky

Oil, Acrylic, Gouache

Titanium white cools and dulls colour. Lighten with a lighter neighbour first (yellow for orange, for example), add only as much white as needed, or use zinc white or a touch of the colour’s warm neighbour to restore warmth.

Darks look dead and flat

Every medium

Black straight from the tube kills chroma. Mix chromatic darks instead: ultramarine + burnt sienna, phthalo green + alizarin, or dioxazine violet + a yellow-orange. They read as black but stay alive.

Acrylics dried a different colour

Acrylic

Wet acrylic binder is milky, so the colour you mix looks lighter than it will dry. Mix slightly lighter than your target and test on a scrap. In the studio here, switch Wet/Dry to preview the change.

Watercolour dried too pale

Watercolour

Watercolour dries lighter and duller, often by 10–30%. Mix stronger than you think, use more pigment and less water for darks, and judge only when dry.

Cauliflowers / blooms in washes

Watercolour

Water flowed back into a drying wash. Keep the water on your brush drier than the wash on the paper, or let it dry fully. Embrace blooms on purpose for skies and foliage.

Greens look artificial

Every medium

Tube greens (especially phthalo) are more intense than most foliage. Mix your own from yellow + blue, warm them with an earth or red, and vary them constantly across the painting.

Skin tones look grey or orange

Oil, Acrylic, Watercolour, Gouache

Start with an earth triad: yellow ochre, a red (vermilion or cadmium red light), and white, plus a cool (ultramarine or black) to neutralise. Warm the lights, cool the half-tones, and watch the temperature, not just the value.

Oil painting is cracking

Oil

Usually lean-over-fat: a fast-drying lean layer was painted over a slower, oilier one. Follow fat over lean, avoid excessive solvent, and let thick layers cure.

Dull patches in my oil painting

Oil

“Sinking in”: oil was absorbed by the layer beneath. Oil out with a thin film of medium wiped back before continuing, or varnish when the painting is fully cured.

Whites are turning yellow

Oil

Linseed oil yellows, especially in the dark. Use whites ground in safflower or poppy oil for the lightest passages, and hang paintings in light.

Pastel won’t stick anymore

Soft pastel

The tooth is full. Brush off excess, use a light spray of workable fixative to restore grip, or work on sanded paper, which takes many more layers.

Paper buckles under water

Watercolour, Gouache

Use 300 gsm (140 lb) or heavier paper, stretch it, or tape it to a board. Blocks (glued on four sides) stay flat.

Paint peeling off

Acrylic, Oil

Adhesion failure: acrylic over oil, painting on a greasy surface, or binder over-diluted with water on a non-absorbent ground. Use medium rather than water for very thin layers and paint on a properly primed surface.

Colours look different in daylight

Every medium

Light source matters: warm bulbs push everything yellow. Paint under neutral daylight-balanced lighting (about 5000–5500 K, high CRI) and check work in natural light.

My painting has no sense of light

Every medium

Light comes from contrast in value and temperature, not white paint. Group your values (squint), keep shadows and lights clearly separated, and choose a light temperature: warm light means cool shadows, and vice versa.

A colour is too strong and takes over

Every medium

High-tinting-strength pigments (phthalos, dioxazine, Prussian) dominate. Add them to the lighter colour, never the other way around, and in tiny amounts.

Can’t lift colour out of my watercolour

Watercolour

Staining pigments (phthalos, quinacridones, dioxazine) bind to the paper fibres. Use non-staining pigments (cobalt, ultramarine, earths) where you plan to lift.

Everything looks the same intensity

Every medium

Give the eye a hierarchy: keep most of the painting at moderate saturation and reserve your highest chroma for the focal area. Bright colours sing next to greys.

My mix matches the photo but looks wrong

Every medium

Photos crush shadows and shift colour. Squint at the subject, compare colours to their neighbours rather than in isolation, and adjust for the surrounding colours (simultaneous contrast).

Colours fade over time

Every medium

Choose ASTM lightfastness I or II paints. Fugitive pigments (genuine alizarin, some dye inks, cheap pinks) fade in sunlight. Check the pigment code on the tube.

Which paints are toxic?

Every medium

Cadmium, cobalt, lead (flake white), chromium and manganese pigments need care: don’t eat or drink while painting, don’t sand or spray them, and wash hands. Pastel dust should not be blown off; tap it into a damp cloth.

Mixes and colours are computed estimates from a physical model. Real paint varies with brand, batch, surface, climate and light, and every screen shows colour differently. Test on a scrap before you commit. Products are sold by independent retailers, and some links earn us a commission. As an Amazon Associate I earn from qualifying purchases.

Chromaraga is free to use. If it helps your painting, you can support it on Patreon or give any amount once through PayPal.

© 2026 Nabil Rahman. Chromaraga™. All rights reserved.